Important note: This solution requires a Hotspot Operator Account at HotSpotSystem.com. You can create an Operator Account here. If you would like to see what features you will be able to use with our solutions, click here. If you already have an Operator Account, then read on...
The following setup is based on Firmware version 4.04b01.
1. Timezone settings
Ensure that no timezone is configured and that the router uses GMT/UTC time.
2.Wan settings
Under Basic Network – WAN, configure your WAN for Internet access.
3.Wifi settings
Under Basic Network – WiFi, configure your WiFi Access Point. For Authentication
select Auto or Open and for Encryption select None.
4.Create a new DHCP server
Under Basic Network – Client/Server, create a new DHCP server.
- DHCP 2, with adifferent IP address range from DHCP 1.
- Reboot the router when prompted.
5.Create a UAM Server
Under System – External Servers, create a UAM Server with the following settings:
6.Radius Server
Under System – External Servers, create a RADIUS Server with the following settings:
7.Captive Portal
Under Applications – Captive Portal, configure the following settings:
8. DHCP settings
Under Basic Network – LAN/VLAN, change the DHCP server for VAP 1 (or the WiFi
Access Points for which you want to use the Captive Portal) to DHCP 2 (or the DHCP server
created in STEP 3).
9. Reboot
Reboot to make sure that settings persist and test your new Hotspotsystem Captive Portal.
Note: Multitech will support the device, customers who have purchased the device can go onto Multitech Support Site to log support requests and can also send queries directly to them at support at 3g.co.za
